Ir directamente a la navegación principal Ir directamente a la búsqueda Ir directamente al contenido principal

Low-frequency amplifiers for PVDF film sensors

Producción científica: Conference contributionrevisión exhaustiva

1 Cita (Scopus)

Resumen

This paper proposes instrumentation amplifiers for use with large area Polyvinylidine Diflouride (PVDF) sensors designed to detect rodent motion. The sensor behaves as a pressure-to-voltage converter in series with a parasitic capacitance. Motion signals critical for classifying rodent behavior range from 0.5 Hz to 20 Hz. Amplification on the order of 20dB is required for the pass-band before digitization. Amplifier A is presently used in an experimental system. This amplifier has slow response time with noticeable drift. Amplifier B is designed to overcome these obstacles. It is more complex but reduces the drift and noise floor, while decreasing the response time. Performance is evaluated with metrics based on low-frequency drift and noise-floor power computed over a 19-hour period and with recovery time from saturation. The comparison shows amplifier B with a faster response and lower drift than amplifier A.

Idioma originalEnglish
Título de la publicación alojadaIEEE SoutheastCon 2008
Páginas75-79
Número de páginas5
DOI
EstadoPublished - 2008
EventoIEEE SoutheastCon 2008 - Huntsville, AL, United States
Duración: abr 3 2008abr 6 2008

Serie de la publicación

NombreConference Proceedings - IEEE SOUTHEASTCON
ISSN (versión impresa)1091-0050
ISSN (versión digital)1558-058X

Conference

ConferenceIEEE SoutheastCon 2008
País/TerritorioUnited States
CiudadHuntsville, AL
Período4/3/084/6/08

ASJC Scopus subject areas

  • Electrical and Electronic Engineering

Huella

Profundice en los temas de investigación de 'Low-frequency amplifiers for PVDF film sensors'. En conjunto forman una huella única.

Citar esto